![]() The collar must be tight to work properly.īatteries should be replaced when the low battery indicator light comes on.ĭo not leave the receiver/collar on the dog continuously. You may need to clip the hair under the dog’s neck if the hair is unusually thick. Is your receiver probes in Contact with Pet?Īre the contact points on the receiver/collar firm against the dog’s skin? You should feel a mild correction when you get close to Place the receiver/collar in the palm of your hand, prongs down, and walk toward the perimeter wire (holding your hand about knee level). Is your receiver/collar giving a correction? Depending on the circumstances, a red light or stop sign violation can run the driver anywhere from about 40 to 155. Wait five minutes before inserting the new battery in order to allow the collar to reset. To insert the battery remove the silver battery cap and remove the old battery. DecemLast Updated on May, 2023 Invisible fences are popular among dog owners because your dog has unrestricted access to roam within your boundary. /rebates/&.com252felectronics252fh6fvx-help-invisible-fence-transmitter-system-flashing-red. You have approximately five days before the battery expires. Is there a two-digit number illuminated? (1 to 30 for signal field)ĭoes your receiver/collar have battery power?Ī bright red blinking light indicates a low battery. Is the AC adaptor plugged in completely to both the outlet and transmitter? If it does not work, then you need an electrician. * This number only indicates signal field width: (it doesn't increase or decrease the correction level)ĭetermine if the outlet has power by plugging in a blow-dryer and seeing if it turns on. ![]() ![]() Over the years we find that most of the time when someone says their fence is not working or the dog thinks there is a hole in the fence, or the dog leaves the yard when there is snow on the ground, we find it is usually a user problem. *The numbers should be a bright green or red color (01-30 in the numbers field) Invisible fence blinking green light on collar We have very few problems of this nature. *Your output level should be set at the number indicated on your installation check list Testing the Transmitter Firstly check the green loop light and red power light are both on If the green light is not on the box should be alarming at you. Note: The green light may be steady green or blinking green. See Owners Guide for additional information. **Any questions not answered her please call or e-mail us, We will be happy to help! If the light is red, the battery needs to be charged. **Some features found on this equipment will not be on any other systems. Your pet wears a receiver collar that picks up the signal. The system works by sending a radio signal through a buried wire (boundary wire). Pet Stop or Perimeter Technolgies Equipment Charge your receiver collar when the receiver indicator light blinks red.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |